Leonard Valve TA-300-LF Single Eye/Face Wash

$475.00
MSRP: $915.00
(You save $440.00 )
Write a Review
Availability:
Usually in Stock, Ships Same Day
Manufacturer Part Number:
TA-300-LF
Model/Series:
Emergency
Inlet:
1/2"
Outlet:
1/2"
Finish:
Rough Bronze
Adding to cart… The item has been added
WARNING: Cancer and Reproductive Harm - www.p65warnings.ca.gov

↓ Headings for tabs. DO NOT CHANGE IN WYSIWYG

↑ End Headings for tabs
↓ Begin to insert your "Description" tab content here

Replaced by: Leonard Valve EXL-300-LF Emergency Mixing Valve For Single/Multiple Eye Or Eye/Face Wash Units

Genuine Leonard Valve TA-300-LF Single Eye/Face Wash.  ECO-MIX DURA-trol solid bimetal thermostat directly linked to valve porting to control the intake of hot and cold water and compensate for supply temperature and pressure fluctuations. DURA-trol is highly responsive and cannot be damaged by extremes in temperature. Thermostatic Mixing Valve can be set to the correct temperature for the application.

Quality Plumbing Supply is a proud distributor of Leonard Valve products. This Leonard Valve TA-300-LF Single Eye/Face Wash is a direct replacement manufactured by Leonard Valve. Order this Leonard Valve TA-300-LF Single Eye/Face Wash today. Most orders usually ship the same day and we offer free shipping for orders over $99!


↑ Stop "Description" content here
↓ Begin to insert your "Specifications" tab content here
  • DURA-trol® solid bimetal thermostat directly linked to valve porting to control the intake of hot and cold water and compensate for supply temperature and pressure fluctuations.  DURA-trol® is highly responsive and cannot be damaged by extremes in temperature.
  • Thermostatic Mixing Valve can be set to the correct temperature for the application.
  • Locking temperature regulator to prevent accidental movement set for 85°F (29°C)
  • Mixing valve will close down on failure of cold water supply
  • Mixing valve with special internal cold water bypass capable of a minimum of 4 GPM (15 l/min) @ 30 PSI (2.1 Bar) upon failure of hot water supply
  • Adjustable high temperature limit stop * set for 90°F (32°C)
  • Integral wall support
  • Sweat ½” top or bottom inlets
  • Threaded ½” top outlet
  • Rough bronze finish
  • Dial thermometer (range 0 to 140°F, -10 to 60°C)
  • Angle checkstops on inlets
  • Compliance…………ANSI Z358.1
  • Maximum supply temperature 180 °F (82°C)
  • Maximum supply pressure 125 PSI (8.6 Bar)

↑ Stop your "Specifications" content here
↓ Begin to insert your "Documentation" tab content here

TA-300-LF Catalog Page

TA-300-LF Maintenance Guide

TA-300-LF Operation & Maintenance Page


↑ Stop your "Documentation" content here